2009/4/18 · Disconnect water tank with filter, put finger on the tip which suppose to suck water. Should fill small suction on the finger. If you fill suction, connect back water tank. If water tank is transparent should see water coming into the boiler. Next step to check if cord between steam generator base and iron is hot, if …
Read MoreIt is common for the Steam generator to experience dip in steam pressure/ output when the water is being pumped from water tank to the boiler. This dip is momentarily and it restores to normal rate. It is also common for the initial burst of steam to be higher and it tapers off to a steady …
Read MoreThe increased steam outlet velocity from the boiler creates an extremely volatile water surface, and the level control system might fail to control. At high loads, in this example, boiler number 4 would lock-out, throwing an already unstable system onto the three remaining boilers, which would soon also lock-out.
Read MoreWhen steam demand from the plant is low, and the boiler is capable of generating more steam than is required, the surplus steam is injected into a mass of water stored under pressure. Over a period of time the stored water content will increase in temperature and pressure until it finally achieves the saturation temperature for the pressure at which the boiler is operating.
Read MoreWhen steam demand from the plant is low, and the boiler is capable of generating more steam than is required, the surplus steam is injected into a mass of water stored under pressure. Over a period of time the stored water content will increase in temperature and pressure until it finally achieves the saturation temperature for the pressure at which the boiler is operating.
Read More